Everything You Need to Know About the Boschmann Equalizer EQX-75PRO
If you’re looking to optimize your sound system with a reliable, top-of-the-line equalizer like Boschmann’s EQX-75PRO, you’ll want to make sure you know how to set it up and use all of its features. Our guide will walk you through the steps of installation, testing, and troubleshooting so that you can get the most out of your new product.
What is the Boschmann EQX-75PRO?
The Boschmann EQX-75PRO is a full-featured professional equalizer designed to deliver maximum sound quality. It features 13 bands of equalization and the ability to balance sound levels; midrange, tweeter, Bass & Overall volume. You can also use it to optimize specific frequencies or tailor an entire system setup to get the best possible sound performance.
Tweaking and Fine Tuning Settings on the EQX-75PRO
With the proper setup in place, you can begin tweaking and fine-tuning your Boschmann EQX-75PRO equalizer. Use the basic frequency analyzer to measure the loudness of each frequency at its maximum output level.
Set a reference point for any peaks or dips in the soundwave. Once you have identified any issues with the EQ’s soundscape, adjust the frequencies using the EQX-75PRO’s built-in knobs to achieve your desired output.
Boschman EQX-75PRO Setup Adjustment
Before Turn ON: Turn the unit Volume to a minimum. Adjust the input gains to a minimum. Turn the source unit volume to the minimum & set the EQ Controls to Flat (12 O’clock )
System Turn ON: After completing all wiring you can turn the system on.
Adjust: Raise the Volume of the Unit to the maximum. Adjust the left-right input gains of the unit until halfway between minimum & maximum.
Gradually increase source volume until the clip. Begin gradually increasing input gains until the distortion is audible, then reduce slightly.
The system should be extremely loaded at this point. Turn the volume control down to a minimum and back up to a comfortable level. Volume changes should sound linear and balanced.
For best results, always use the main volume as a master volume control. Main Volume Control has better electronics, a higher Signal to Noise ratio, and is more linear than any source unit volume available.
If Engine Noise is audible, try raising the volume on the source unit, and/ or check the ground connection on the unit.
How easy was it for use to set up and adjust the Boschmann EQX-75PRO Equalizer?